BENTLY 330180-51-05 Central control module

Bently Nevada 330180-51-05 Overview

The Bently Nevada 330180-51-05 is a non-contacting Eddy Current proximity probe belonging to the 3300 XL series. It is typically used with a 3300 XL extension cable and a monitor to measure radial vibration, axial (thrust) position, and changes in speed on rotating machinery. The probe itself does not provide a direct output but functions as part of a sensor system.

Product Detailed Description

• Function:

• Detects radial vibration of rotating machinery shafts.

• Measures axial (thrust) position of rotating machinery shafts.

• Senses changes in speed of rotating machinery (through the rate of change of vibration or position signals).

• Converts mechanical motion into an electrical signal for further processing and analysis by a monitor.

• Features:

• Non-contacting measurement eliminates mechanical wear.

• High accuracy and reliability.

• Suitable for a wide range of rotating machinery.

• Requires use with a 3300 XL extension cable and a compatible monitor.

• The probe tip material is typically PPS (Polyphenylene Sulfide), offering good resistance to high temperatures and chemical corrosion.

Product Parameters

As the 330180-51-05 is a specific model number, the following parameters are inferred based on the model information. Always refer to the official Bently Nevada datasheet for precise specifications:

• Probe Model: 330180

• Probe Diameter: Typically 8 mm (standard diameter for the 3300 XL series).

• Case Thread: Likely M10x1 or 3/8-24 UNF (the "-51" portion may indicate the thread type and length).

• Overall Length: The "05" portion typically indicates the overall length of the probe, possibly in coded values representing inches or centimeters. Refer to the datasheet for the exact length.

• Tip Material: PPS (Polyphenylene Sulfide).

• Target Material: Conductive metal.

• Frequency Response: Typically 0 Hz to 10 kHz (system dependent).

• Linear Range: Refer to the specific model's datasheet.

• Sensitivity: Typically around 7.87 V/mil (310 mV/µm), but depends on system calibration.

• Operating Temperature: Typically -51 °C to +177 °C (-60 °F to +350 °F).

• Cable Connection: Requires connection to a 3300 XL series extension cable.

Product Advantages

• Non-Contacting Measurement: Eliminates mechanical wear, extending service life and improving reliability.

• High Accuracy: Provides precise vibration and position measurements for early fault detection.

• Early Fault Detection: Monitoring vibration and position changes allows for early detection of mechanical faults, preventing catastrophic damage.

• Improved Machine Reliability: Continuous monitoring helps optimize maintenance schedules and improve overall machine reliability.

• Suitable for Harsh Environments: Designed for various industrial environments.

Precautions

• Correct Installation: Follow Bently Nevada's installation guidelines, including proper probe gap setting.

• Use Compatible Cables and Monitors: Must be used with a 3300 XL series extension cable and a compatible monitor.

• Environmental Conditions: Avoid using the probe in environments exceeding its operating temperature range.

• Target Surface Condition: The target shaft surface should be clean and have appropriate electrical conductivity.

• Regular Inspection: Periodically inspect the probe, cable, and connections for damage.

• Avoid Physical Damage: Protect the probe from physical shock and excessive vibration.

• Grounding: Ensure the system is properly grounded to avoid noise interference.

Product Applications

• Steam and Gas Turbines: Monitoring shaft vibration and axial position.

• Compressors: Monitoring rotor radial and axial movement.

• Pumps: Detecting vibration caused by imbalance, misalignment, and bearing failures.

• Motors and Generators: Monitoring bearing condition and rotor dynamics.

• Gearboxes: Detecting gear meshing problems and bearing failures.

• Any Rotating Machinery: Used for predictive maintenance and machinery protection.

Shipping Port: Xiamen, China